Omron SYSMAC C200H-OV001 Operation Manual page 31

REC Mode
Input Device Connection
Set the mode selector to
REC
Adjust the input level
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
A microphone or tape recorder can be connected to the Voice Unit. Using a
microphone is simpler, however using a tape recorder improves the sound
quality of the recorded message.
When using a tape recorder, recording a signal sound (such as beep) to id-
entify the beginning of the message is recommended.
Connect a microphone or tape recorder to the message input jack of the
Voice Unit (for details, refer to 1-3 Input/Output Device Connections .
Set the line/microphone selector switch according to the input device con-
nected. When a tape recorder is used, set the switch to the L position; set it
to the microphone position when using a microphone.
Set the recording time by using pins 5 and 6 of the DIP switch on the back
panel of the Voice Unit.
Set the memory protect switch, which is in the battery compartment, to the
OFF position.
When the Voice Unit is being used for the first time, be sure to clear the
memory.
When the Voice Unit is ready for recording, the REC indicator will begin blink-
ing at 0.5 second intervals.
Mode
selector
switch
REC
When the REC indicator is blinking, the Voice Unit is ready for recording. In-
put the message to be recorded.
At this time, the input level of the message can be adjusted by using the in-
put volume control. To check the actual message playback volume, connect
an external speaker directly or via an amplifier to the message output jack
(for speaker and amplifier connection, refer to 1-3 Input/Output Device Con-
nections .
Adjust the input level of the message as the message is being recorded.
When a tape recorder is used, also adjust the output volume of the tape re-
corder
IN-VOL
(input volume control)
Clockwise increases the input volume.
The OVF indicator indicates that an appropriate input level has been selected
by blinking intermittently. With an external speaker connected, check the
message playback sound quality while adjusting the input level.
RUN
PLAY
REC
ERR
Ç Ç Ç Ç
Intermittent blinking of the OVF indicator indicates that
OVF
an appropriate input level has been selected
RUN
The REC indicator is blinking at
PLAY
0.5 second intervals (indicating
REC
recording standby status)
ERR
OVF
Section 3-3
23