Omron SYSMAC C200H-OV001 Operation Manual page 26

Bit Number Allocation
I/O Word Bit number
n+6 15 through 08
07 through 00
Output n+7 15 through 08
07 through 00
n+8 15 through 08
07 through 00
Input n+9
06 through 07
08 through 13
14 through 15
n = 100 + 10 x unit no.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Bit name
11th phrase no.
12th phrase no.
13th phrase no.
14th phrase no.
15th phrase no.
16th phrase no.
00 ON-LINE
01 Voice Unit busy
02 Message
playback in
progress
03 Output memory
area FULL
04 Voice Unit error
05 Battery error
---
Setting switch
---
The Voice Unit is equipped with an output memory area in which the output
commands for several messages are stored. In sentence mode (one-shot
operation mode), up to 20 messages can be stored in this area. In phrase
combination mode, up to 20 messages can be stored with each message
consisting of phrases 1 through 16. (The message being reproduced is not
included in the number of messages that can be stored.)
Function
This bit turns ON when the Voice Unit mode selector switch
is set to ON-LINE.
This bit turns ON when the Voice Unit recognizes the ON
status of an output command in ON-LINE mode. It remains
ON until the Unit recognizes the OFF status of the
command.
This bit turns ON during message playback (in ON-LINE
mode only). If the message is to be played back
repeatedly, this bit remains ON until the message has been
played back the specified number of times.
This bit turns ON when the number of messages stored in
memory reaches 20 (for ON-LINE and one-shot operation
modes only).
This bit turns ON if a Voice Unit error occurs or when a
BCD data error occurs in ON-LINE mode.
This bit turns ON when the battery supply voltage is low, or
when the battery is not connected correctly.
Not used
These bits output the setting status of the Voice Unit back
panel DIP switches (0 = OFF, 1 = ON). Pins 1 through 6 of
the DIP switch correspond respectively bits 08 through 13.
Not used
Section 2-2
17