Omron SYSMAC C200H-OV001 Operation Manual page 32

REC Mode
Record messages
Example
24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Assign a message number to each of the recorded messages with the MSG
No. increment and decrement switches. The message number allocated by
these switches is displayed on the LED MSG No. display. Message numbers
from 01 through 60 can be allocated.
In sentence mode, Message no. 01 and Message no. 60 have the highest
and lowest priority respectively.
Prepare the input device (microphone or tape recorder) for recording. (When
a tape recorder is used, recording a signal sound such as a beep to indicate
the beginning of a message is recommended.)
Push the ST/SP switch. The REC indicator is lit, and recording will begin.
RUN
PLAY
REC
ERR
OVF
In this example, message no. 4 is being recorded.
Note Recording is interrupted if the mode is changed during recording. To change
a recorded message, erase the message once, and then record the new
message. After recording a message, set the memory protect switch to the
ON position. It is recommended that the recorded message be copied to pe-
ripheral devices for storage. When the ERR indicator lights, refer to 5-1 Error
Codes .
MSG No. indicator
(01 through 60)
Push the MSG No. increment/decre-
ment switch to increment/decrement
the message number.
To stop recording, push the ST/SP
switch once again.
When recording is finished, the
Voice Unit enters standby status.
Section 3-3
MSG No.
increment switch
MSG No.
decrement switch