Omron SYSMAC C200H-OV001 Operation Manual page 37

ERASE Mode
Memory Failure due to
cause 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
ERA
Mode
selector
switch
RUN
PLAY
REC
ERR
OVF
RUN
PLAY
REC
ERR
OVF
When mode selector
switch is in a position other
than ERA and RCV these
conditions can be expected
In this state, the only choice that exists is to erase all the messages; to do
this push the ST/SP switch.
After pushing the ST/SP switch the PLAY and REC indicators will be lit and
all messages in the memory will be erased.
RUN
PLAY
REC
ERR
OVF
The messages are completely erased even if the ST/SP switch is pushed
during the message erasure procedure.
When the messages have all been erased, "00" is displayed on the MSG No.
indictor display, and the Voice Unit enters erasure standby status. From this
state, other modes can be selected and executed.
In this situation operation is possible only in ERA or RCV mode. In the re-
maining modes, RUN and ERR indicators are lit and the Unit is not operative.
When in ERA mode, the message number responsible for the memory failure
is displayed on the MSG No. indicator display, and the PLAY and REC indi-
cators are blinking at 0.5 second intervals.
Either one or two messages may cause a memory failure in case (2). If there
are two messages causing the failure, their numbers are alternately dis-
played at 0.5 second intervals on the MSG No. indicator display.
Display in ERA mode. "00"
is blinking on MSG No. indi-
cator display (in this situa-
tion the MSG No. cannot be
incremented or decrem-
ented).
Voice Unit memory failure
indicator display for modes
other than ERA and RCV
mode (the Voice Unit can-
not operate in this state)
The MSG No. indicator
display remains OFF.
All messages are erased. At
this time, "00" is displayed
on MSG No. indicator.
Section 3-5
29