Omron SYSMAC C200H-OV001 Operation Manual page 36

ERASE Mode
Erasing after a Message
Memory Error
1, 2, 3... 1.
Memory failure due to
cause 1
28
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Push the ST/SP switch. The PLAY and REC indicator will light, and the mes-
sage indicated by the MSG No. indicator will be erased.
RUN
PLAY
REC
ERR
OVF
Pushing the ST/SP switch during message erasure has no interrupting effect.
After a message has been erased, the Voice Unit enters standby status.
The sum total of the recording time before erasure and the time required for
erasure becomes the new recording time.
Note If the ERR indicator is lit, refer to 5-1 Error Codes .
If the message memory of the Voice Unit has failed, messages should be
erased differently from the method described earlier. Message memory fail-
ure is caused by the following two sets of circumstances:
The data in the memory is replaced with incorrect data (for any reason)
2. The power is turned OFF or the PC is reset during message recording
or erasure
If the message memory has failed, it is necessary to either erase the con-
tents of the message memory or rewrite its contents.
The contents of the message memory must be erased differently for circum-
stances (1) and (2) above. (For rewriting the message memory contents in
RCV mode, refer to 3-7 XMT/RCV Mode .
In this situation only the RUN and ERR LED indicators are lit, and the Unit is
not operative excluding in the ERA and RCV modes.
When ERA mode is selected, "00" is displayed on the MSG No. indicator, and
the PLAY and REC indicator are blinking at 0.5 second intervals.
MSG No. indicator
(00 through 60)
Push the MSG No. increment/decre-
ment switch to increment/decrement
the displayed message number.
(Example)
In this example Mes-
sage no. 32 is erased.
Section 3-5
MSG No. increment
switch
MSG No. decrement
switch