Omron SYSMAC C200H-OV001 Operation Manual page 74

Phrase Combination Mode Example Programs
66
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The following phrases are assigned to each Phrase no.:
Phrase no. 5 = "Unit 5"
Phrase no. 7 = "Unit 7"
Phrase no. 17 = "Requires"
Phrase no. 31 = "Materials"
Note If the number of phrases used is less than 16, set the last Phrase no. to "00".
00100
00101
03000
03001
00102
The messages, for the above program, are issued as follows:
This command transfers repetition (3
@MOV
times) and interval data (0.3 s) to the
#0033
Voice Unit (when input 00100 turns ON).
120
This command sets Phrase no. 5 as
@MOV
the first phrase and Phrase no. 17 as
#0517
the second phrase (when input 00100
121
turns ON).
This command sets Phrase no. 31 as
@MOV
the third phrase and Phrase no. 00 as
#3100
the fourth and last (Phrase no. 00 sig-
122
nifies the last phrase) phrase (when
input 00100 turns ON).
DIFU
03000
This command transfers repetition (3
@MOV
times) and interval data (0.3 s) to the
#0033
Voice Unit (when input 00101 turns ON).
120
This command sets Phrase no. 7 as
@MOV
the first phrase and Phrase no. 17 as
#0717
the second phrase (when input 00101
121
turns ON).
This command sets Phrase no. 31 as
@MOV
the third phrase and Phrase no. 00 as
#3100
the fourth and last (Phrase no. 00 signi-
122
fies the last phrase) phrase (when input
00101 turns ON).
DIFU
03001
12014
Output command.
12015
Stop command (while input 00102 is
ON).
Section 4-2