Programming Of The Pmcprimo Drive3 - Pilz PMC Series Installation Manual

10 Setup
10.5

Programming of the PMCprimo Drive3

All programming of the PMCprimo Drive3 is done with the terminal program PTERM or, as an
option, with the soft PLC development system CoDeSys
A succesful optimation of the PMCprimo Drive3 position controller is only possible after
an well done optimation of the current and speed controllers with PDRIVE.
For further details see the the PMCprimo programming manual.
Installation manual for PMC tendo DD5/PMCprimo Drive3
®
from 3S.
Page 97