Preparing The Instrument; Install The Battery - GE Measurement & Control Druck DPI 620 Genii User Manual
Advanced modular calibrator
Hide thumbs
Also See for Measurement & Control Druck DPI 620 Genii:
- User manual (175 pages) ,
- Quick start manual (154 pages)
Table of Contents
Advertisement
User Manual
• Connect only clean equipment to the instrument. To
avoid any contamination, an external filter is
recommended
1.8
Preparing the Instrument
On receipt of the instrument check the contents in the
box, listed in section 1.1. It is recommended to retain the
box and packaging for future use
1.9
Install the Battery
1.
Remove the five Pozidriv screws (A) (Ref: Figure 1-1)
2.
Remove the battery cover
3.
Check the connections on the battery line up with the
connections in the battery compartment
4.
Place the battery in the battery compartment
5.
Replace the battery cover
6.
Secure the cover with the five Pozidriv screws
06 June 2013
Druck DPI620 Genii
Page 17 of 179
Advertisement
Table of Contents
