Replacing The Speaker - Christie DHD410S Service Manual

2. Remove the main board.
See
Replacing the main board
3. Remove the combiner module.
See
Replacing the combiner module
4. Remove the laser driver board.
See
Replacing the laser driver board
5. Remove the front cover.
See
Removing the front cover
6. Remove two screws to separate the interlock switch from the front cover.
7. Remove the interlock switch harnesses from the clips.
8. Replace the interlock switch.
9. To re-install, follow these steps in reverse order.

Replacing the speaker

To remove the speaker, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Unplug the connector on the main board, and remove one screw with a Phillips #1 screwdriver.
3. Take out speaker.
4. Separate the speaker from rubber.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 77.
on page 73.
on page 82.
on page 48.
on page 46.
Electronics
57