Christie DHD410S Service Manual page 71

Item Male connector on
connector board
I
LD IF
J DMD FAN
K SYS FAN3
L SYS FAN2
M SYS FAN1
5. On the main board, remove the four M3 screws with a Phillips #1 screwdriver securing the main
board module.
6. Remove four screws to separate main board module from the bottom shielding.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
Description
FPC Cable
Composed of red, blue, and black wires, a
white connector, and a black wire tube (three
pin)
Composed of white, yellow, red, black, and gray
wires, a white connector, and a black wire tube
(five pin)
Composed of red, yellow, and black wires, a
white connector, and a black wire tube (three
pin)
Composed of red, yellow, and black wires, a
white connector, and a black wire tube (three
pin)
Printed circuit boards and sensors
Figure
71