Table of Contents
Advertisement
•
Microsoft Edge: version 40 or higher is required.
•
Chrome: version 63 or higher is required.
•
Firefox: version 57 or higher is required.
•
Safari: version 11 or higher is required.
To perform the network function test, complete the following steps.
1. Record the projector IP address.
a. Plug in the power cord to the projector.
b. Connect PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, press Menu and select Configuration > Communications
> LAN.
e. Make sure DHCP is disabled.
f. Record the following information:
•
The IP address: 10.0.21.200 (default)
•
The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
a. On the PC, double-click Local Area Connection.
b. Click Properties.
c. Select Internet Protocol (TCP/IP).
d. Click Properties.
e. Set the IP Address to 10.0.21.201.
f. Set the Subnet Mask to 255.255.255.0.
The Host ID (10.0.21.XXX) of the PC IP Address must be different from the projector IP
address.
g. Click OK.
h. Click Close.
3. Read the projector information.
a. Connect the PC and the projector Ethernet Port with a RJ45 cable.
b. Use a web browser to navigate to http://10.0.21.100.
c. For the Access type, select Administrator.
d. Enter the password admin.
e. Click Login.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
Service setups
20
Advertisement
Table of Contents
