Performance Specifications (G7129B) - Agilent Technologies InfinityLab LC Series User Manual

Performance Specifications (G7129B)

Table 3 Performance Specifications (G7129B)
Type Specification
Injection range 0.1 – 20 µL in 0.1 µL increments (default)
0.1 – 40 µL in 0.1 µL increments (if 40 µL loop is
installed)
0.1 – 120 µL in 0.1 µL increments with 1290
Infinity large volume injection kit (hardware
modification required)
0.1 – 100 µL in 0.1 µL (if 100 µL-loop and
100 µL-head is installed)
<0.25 % RSD of peak areas from 5 µL to 100 µL
Injection precision
Pressure range Up to 130 MPa (1300 bar, 18854 psi)
Sample viscosity 0.2 – 5 cp
range
Sample capacity 132 x 2 mL vial (two trays default)
100 x 2 mL vial (two classic trays optional)
36 x 6 mL vials (two trays optional)
<0.004 % (40 ppm) with needle wash
Carry over
Injection cycle time 18 s for draw speed 200 µL/min
Ejection speed: 200 µL/min
Injection volume: 1 µL
Minimum sample 1 µL from 5 µL sample in 100 µL microvial, or
volume 1 µL from 10 µL sample in 300 µL microvial.
Instrument Control LC & CE Drivers A.02.12 or above
Instrument Control Framework (ICF) A.02.03 or
above
Instant Pilot (G4208A) with firmware B.02.19 or
above
Lab Advisor B.02.07 or above
Communications Controller-area network (CAN),Local Area
Network (LAN)
ERI: ready, start, stop and shut-down signals
Agilent InfinityLab LC Series Vialsamplers User Manual
Site Requirements and Specifications
Performance Specifications
Comment
Up to 1500 µL (with 1400 µL-multi-draw kit and
100 µL-analytical head)
up to 130 MPa (1300 bar, 18854 psi)
up to 60 MPa (600 bar, 8702 psi)
Measured caffeine
Needle height offset has to be adapted to
ensure that needle doesn't touch vial bottom.
Default needle height = 0 equates to 2 mm
above the vial bottom.
For details about supported software versions
refer to the compatibility matrix of your version
of the LC and CE Drivers
2
43