Agilent Technologies InfinityLab LC Series User Manual page 39

Bench Space
The module dimensions and weight (see
the module on almost any desk or laboratory bench. It needs an additional
2.5 cm (1.0 inches) of space on either side and approximately 8 cm
(3.1 inches) in the rear for air circulation and electric connections.
If the bench shall carry a complete HPLC system, make sure that the bench is
designed to bear the weight of all modules.
The module should be operated in a horizontal position, especially if a sample
cooler or sample thermostat is installed. Use a bubble level to check the
leveling of the sampler.
Agilent recommends that you install the HPLC instrument in the InfinityLab Flex Bench
N O T E
rack. This option helps to save bench space as all modules can be placed into one single
stack. It also allows to easily relocate the instrument to another laboratory.
Heavy weight
WA R N I N G
The module is heavy.
➔
➔
➔
➔
Condensation
Condensation within the module
C AU T I O N
Condensation can damage the system electronics.
➔
➔
Agilent InfinityLab LC Series Vialsamplers User Manual
Carry the module at least with 2 people.
Avoid back strain or injury by following all precautions for lifting heavy objects.
Ensure that the load is as close to your body as possible.
Ensure that you can cope with the weight of your load.
Do not store, ship or use your module under conditions where temperature
fluctuations could cause condensation within the module.
If your module was shipped in cold weather, leave it in its box and allow it to warm
slowly to room temperature to avoid condensation.
Site Requirements and Specifications
Site Requirements
Table 1 on page 40) allow you to place
2
39