Table of Contents
Advertisement
8.
Install the access panel.
9.
Install the server into the rack.
10. Connect all peripheral cables to the server.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server.
The installation is complete.
Installing the M.2 SSD enablement option
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
T-15 Torx screwdriver
•
Phillips No. 1 screwdriver
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5.
Remove the access panel.
6.
Remove the riser cage.
7.
Remove the riser blank.
8.
Install the SSD module on the M.2 SSD enablement board:
a. Insert the SSD module into the SSD slot at a 45 degree angle, and then gently press it down against the M.2 SSD
Enablement board.
b. Secure the SSD module to the M.2 SSD enablement board with a screw.
c. To install a second SSD module, repeat the process.
74
Hardware options installation
Advertisement
Table of Contents
