Accelerator Pedal - Mitsubishi ASX 2019 Owner's Manual

NOTE
l If the battery voltage is insufficient, the
memory data for the cruise control may be
erased.
As a result, the "CRUISE" indication lamp
may not come on when you restart the en-
gine.
If this happens, press the CRUISE CON-
TROL ON/OFF switch once again to turn on
the cruise control.
2. Accelerate or decelerate to your desired
speed, then push down and release the
SET - switch (B) when the "CRUISE"
indication lamp is illuminated. The vehi-
cle will then maintain the desired speed.
NOTE
l When you release the SET - switch, the ve-
hicle speed will be set.
To increase the set speed
There are 2 ways to increase the set speed.
RES + switch
Push up and hold the RES + switch (C) while
driving at the set speed, and your speed will
then gradually increase.
When you reach your desired speed, release
the switch. Your new cruising speed is now
set.
To increase your speed in small amounts,
push up the RES + switch for less than about
1 second and release it.
Each time you push up the RES + switch,
your vehicle will go about 1.6 km/h (1 mph)
faster.
OGAE19E1
Cruise control*

Accelerator pedal

While driving at the set speed, use the accel-
erator pedal to reach your desired speed and
then push down the SET - switch (B) and re-
lease the switch momentarily to set a new de-
sired cruising speed.
To decrease the set speed
There are 2 ways to decrease the set speed.
SET - switch
Push down and hold the SET - switch (B)
while driving at the set speed, and your speed
will slow down gradually.
Starting and driving
6
6-43