Mitsubishi ASX 2019 Owner's Manual page 227

To operate
When the BSW switch is pressed while the
ignition switch is turned to the "ON" position
or the operation mode is put in ON, the
dicator (green) will appear on the information
screen of the multi-information display and
the BSW will enter the standby state.
in-
When the BSW switch is pressed again, the
indicator on the information screen of the
multi-information display will then go out
and the BSW will turn off.
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
OGAE19E1
Blind Spot Warning (BSW) (with Lane Change Assist)*
NOTE
l After the system check screen disappears,
the indicator (green) appears on the infor-
mation screen of the multi-information dis-
play.
Refer to "Information screen (when the igni-
tion switch is turned from the "LOCK" posi-
tion to the "ON" position or the operation
mode is changed from OFF to ON)" on page
5-08.
l When the ignition switch is turned to the
"LOCK" position or the operation mode is
set to OFF, the selected condition (BSW
ON/OFF) just before setting to OFF is re-
tained.
l The BSW operates when all of the following
conditions are met.
• The ignition switch is turned to the "ON"
position or the operation mode is put in
ON.
• The selector lever is in positions other
than "P" (Park) and "R" (Reverse).
• The speed of your vehicle is approximate-
ly 10 km/h or higher.
When the sensor detects an ap-
proaching vehicle
When the indicator (green) appears on the
information screen of the multi-information
display, if a vehicle is approaching your vehi-
cle in the detection area, the BSW lamp in
the outside rear-view mirror illuminates.
Starting and driving
6
6-57