Stopping The Engine - Mitsubishi ASX 2019 Owner's Manual

3. If the engine still will not start, the en-
gine could be flooded with too much
petrol. While depressing the brake pedal
(CVT) or the clutch pedal (M/T), push
the accelerator pedal all the way down
and hold it there, then press the engine
switch to crank the engine. If the engine
does not start after 5 to 6 seconds, push
the engine switch to stop cranking the
engine, and release the accelerator pedal.
Put the operation mode in OFF. Wait a
few seconds, and then press the engine
switch to crank the engine again while
depressing the brake pedal (CVT) or the
clutch pedal (M/T), but do not push the
accelerator pedal. If the engine fails to
start, repeat these procedures. If the en-
gine still will not start, we recommend
you to have the vehicle checked.

Stopping the engine

WARNING
l Do not operate the engine switch while
driving except in an emergency. If the en-
gine is stopped while driving, the brake
servomechanism will cease to function
and braking efficiency will deteriorate.
Also, the power steering system will not
function and it will require greater man-
ual effort to operate the steering. This
could result in a serious accident.
NOTE
l If you have to bring the engine to an emer-
gency stop while driving, press and hold the
engine switch for 3 seconds or more, or
press it quickly 3 times or more. The engine
will stop and the operation mode will go to
ACC.
l Do not stop the engine with the selector lev-
er in any position other than the "P" (PARK)
position (or CVT). If the engine is stopped
with the selector lever in any position other
than the "P" (Park) position, the operation
mode will go to ACC rather than OFF.
Put the operation mode in OFF after placing
the selector lever in the "P" (Park) position.
1. Stop the vehicle.
2. Fully engage the parking brake while de-
pressing the brake pedal.
OGAE19E1
Keyless operation system*
3. On vehicles with M/T, press the engine
switch to stop the engine, move the gear-
st
shift lever to the 1 (on an uphill) or "R"
(Reverse) (on a downhill) position.
On vehicles with CVT, move the selec-
tor lever to the "P" (PARK) position,
press the engine switch to stop the en-
gine.
If the keyless operation key is
not operating properly
Insert the keyless operation key into the key
slot in the glove box. Starting the engine and
changing the operation mode should now be
possible.
Remove the keyless operation key from the
key slot after starting the engine or changing
the operation mode.
Locking and unlocking
3
3-19