Mitsubishi ASX 2019 Owner's Manual page 158

Combination headlamps and dipper switch
When the sensor performance returns, the
AHB will resume operation.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the sensor has a malfunction. Contact a
MITSUBISHI MOTORS Authorized Service
Point for inspection of the sensor.
5
5-56 Instruments and controls
Welcome light*
This function turns on the position and tail
lamps for about 30 seconds after the UN-
LOCK switch (A) on the remote control
transmitter is pressed when the combination
headlamps and dipper switch is in the "OFF"
or "AUTO" position (for vehicles equipped
with the automatic lamp control). On vehicles
equipped with automatic lamp control, the
welcome light function will operate only
when it is dark outside the vehicle.
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
OGAE19E1
NOTE
• Turn the combination headlamps and dip-
per switch to the " " or "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Coming home light
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the ignition switch is turned to the "LOCK"
position or the operation mode is put in OFF.
" position.