Mitsubishi ASX 2019 Owner's Manual page 88

Child restraint
It is not necessary to retain the child restraint
system using the vehicle's seat belts.
4
A- Child restraint system connectors
To install
1. Remove any foreign material in or
around the connectors and ensure the ve-
hicle seat belt is in its normal storage po-
sition.
2. Remove the head restraint from the loca-
tion in which you wish to install a child
restraint.
Refer to "Head restraints" on page 4-07.
3. Open the gap a little between the seat
cushion (A) and the seatback (B) with
your hand to locate the lower anchorages
(C).
4. Push the child restraint system's connec-
tors (D) into the lower anchorages (C) in
accordance with the instructions provi-
ded by the child restraint system's manu-
facturer.
4-22 Seat and seat belts
A- Vehicle seat cushion
B- Vehicle seatback
C- Lower anchorage
D- Connector
If your child restraint system requires
the use of a tether strap, fasten the tether
strap in accordance with steps 5.
5. Latch the tether strap hook (E) of the
child seat to the tether anchorage bar (F)
and tighten the top tether strap hook so it
is securely fastened.
OGAE19E1
NOTE
l If it is difficult to latch the tether strap hook
(E), turn the hook sideways.
6. Push and pull the child restraint in all di-
rections to be sure it is secure.
To remove
Remove the child restraint in accordance
with the instructions provided by the child re-
straint system's manufacturer.