Mitsubishi ASX 2019 Owner's Manual page 188

Auto Stop & Go (AS&G) system*
CAUTION
• When the air conditioning is operated in
AUTO mode where the temperature con-
trol dial is set to the max. hot or the max.
cool position (for vehicles with automatic
air conditioning).
• When the air conditioning is ON, the pas-
senger compartment temperature rises and
the air conditioning compressor operates
6 to lower the temperature.
• Mode selection dial is set to the demister
position.
Refer to "Demisting of the windscreen
and door windows: For quick demisting"
on page 7-09.
• Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
• Driver's seat belt is unfastened.
• Driver's door is open.
NOTE
l If the "Auto Stop & Go (AS&G) OFF"
switch is pressed to deactivate the Auto Stop
& Go (AS&G) system while the engine is
stopped automatically, the engine will not
restart automatically even if the clutch pedal
is depressed.
6-18 Starting and driving
NOTE
l If the bonnet is opened when the engine is
automatically stopped, the " " display/ in-
dicator will blink, the buzzer will sound, and
the engine will not restart automatically. To
restart the engine, fully depress the clutch
pedal while depressing the brake pedal, and
then turn the ignition switch to the "START"
position or press the engine switch. For de-
tails, refer to "Starting and stopping the en-
gine" on page 3-17 or "Starting" on page
6-13.
l When the engine restarts automatically, the
audio volume may temporarily decrease.
This does not indicate a malfunction.
l When the engine is stopped automatically,
the air conditioning may temporarily change
the air volume.
This does not indicate a malfunction.
To deactivate
The Auto Stop & Go (AS&G) system is auto-
matically activated when the ignition switch
is turned to the "ON" position. You can deac-
tivate the system by pressing the "Auto Stop
& Go (AS&G) OFF" switch.
When the Auto Stop & Go (AS&G) system is
deactivated, the " " display/indicator will
turn on.
OGAE19E1
To reactivate the Auto Stop & Go (AS&G)
system, press the "Auto Stop & Go (AS&G)
OFF" switch; the display/indicator will turn
off.
Type 1 Type 2
NOTE
l
This display/indicator will also turn on for a
few seconds when the ignition switch is
turned to the "ON" position or the operation
mode is put in ON.
If the display/indicator
blinks while driving
If the " " display/indicator blinks, the Auto
Stop & Go (AS&G) system is malfunctioning
and will not operate.