Mitsubishi ASX 2019 Owner's Manual page 58

Security alarm system*
3
3. Pull the windscreen wiper and washer
switch towards you and hold it there.
(Since the ignition switch is in the
"LOCK" position or the operation mode
is in OFF, washer fluid will not be
sprayed.)
3-34 Locking and unlocking
4. After approximately 10 seconds, the
buzzer will make a sound. Keep the
windscreen wiper and washer switch
pulled towards you. (If the windscreen
wiper and washer switch was released,
the setting change mode would be can-
celled. To start over, perform the proce-
dure again from step 3.)
5. When the buzzer stops, with the wind-
screen wiper and washer switch still
pulled towards you, press the UNLOCK
switch (A) on the remote control switch
to select the security alarm settings
mode.
Except for vehicles equipped with the keyless
operation system
OGAE19E1
Vehicles equipped with the keyless operation system
The settings mode can be toggled by
pressing the UNLOCK switch. The
mode can be confirmed from the number
of times the buzzer sounds.
Number of
times the Security alarm settings
buzzer mode
sounds
1 Alarm inactive
2 Alarm active
6. Any of the following operations can be
used to terminate the system settings
change mode.
• Releasing the windscreen wiper and
washer switch.
• Closing the driver's door.