Mitsubishi ASX 2019 Owner's Manual page 301

You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
Speaker enrollment
It takes about 2 to 3 minutes to complete the
speaker enrollment process.
To ensure the best results, run through the
process while in the driver's seat, in an envi-
ronment that is as quiet as possible (when
there is no rain or strong winds and the vehi-
cle windows are closed). Please turn off your
phone while in speaker enrollment to prevent
interruption of the process.
Use the following procedure for speaker en-
rollment.
1. Stop your vehicle in a safe area, put the
gearshift lever in the "N" (Neutral) posi-
tion (M/T), or the selector lever in the
"P" (PARK) position (CVT), and pull
the parking brake lever.
NOTE
l Speaker enrollment is not possible unless the
vehicle is parked. Make sure you park the
vehicle in a safe area before attempting
speaker enrollment.
2. Press the SPEECH button.
3. Say "Voice training".
4. The voice guide will say "This operation
must be performed in a quiet environ-
ment while the vehicle is stopped. See
the owner's manual for the list of re-
quired training phrases. Press and re-
lease the SPEECH button when you are
ready to begin. Press the HANG-UP but-
ton to cancel at any time".
Press the SPEECH button to start the
speaker enrollment process.
NOTE
l If you do not start the speaker enrollment
process within 3 minutes of pressing the
SPEECH button, the speaker enrollment
function will time out.
The voice guide will say "Speaker Enroll-
ment has timed out". The system will then
beep and the voice recognition mode will be
deactivated.
5. The voice guide will prompt for phrase
1. Repeat the corresponding phrase lis-
ted in table "Enrollment commands" on
page 7-67.
The system will register your voice and
then move on to the registration of the
next command. Continue the process un-
til all phrases have been registered.
NOTE
l
To repeat the most recent voice training
command, press and release the SPEECH
button.
OGAE19E1
®
Bluetooth 2.0 interface*
NOTE
l If you press the HANG-UP button anytime
during the process, the system will beep and
stop the speaker enrollment process.
6. When all enrollment commands have
been read out, the voice guide will say
"Speaker enrollment is complete".
The system will then end the speaker en-
rollment process and return to the main
menu.
NOTE
l Completing the speaker enrollment process
will turn on the voice model automatically.
l
The commands "Help" and "Cancel" will
not work in this mode.
Enabling and disabling the
voice model and retraining
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
You can also retrain the system.
Use the following procedure to perform these
actions.
1. Press the SPEECH button.
2. Say "Voice training".
For pleasant driving
7
7-51