Dead Lock System - Mitsubishi ASX 2019 Owner's Manual

Dead Lock System*

NOTE
l Repeated continuous operation between lock
and unlock could activate the central door
3
locking systems built-in protection circuit
and prevent the system from operating.
If this occurs, wait approximately 1 minute
before operating the central door lock
switch.
l When the driver's door is open, the central
door lock switch cannot be used to lock it.
To lock and unlock the doors
and tailgate
Using the central door lock
switch
Using the central door lock switch on the
driver's door locks or unlocks all doors and
the tailgate.
LHD
3-26 Locking and unlocking
RHD
1- Lock
2- Unlock
To unlock the doors and tail-
gate
You can select the functions to unlock the
doors and tailgate either using the ignition
switch or the engine switch, or using the se-
lector lever position (CVT).
These functions are not activated when the
vehicle is shipped from the factory. To acti-
vate or deactivate these functions, please
contact a MITSUBISHI MOTORS Author-
ized Service Point.
Using the ignition switch or the
engine switch
All doors and the tailgate will unlock when-
ever the ignition switch is turned to the
"LOCK" position or the operation mode is
put in OFF.
OGAE19E1
Using the selector lever position
(CVT)
All doors and the tailgate will unlock when-
ever the selector lever is moved to the "P"
(PARK) position with the ignition switch in
the "ON" position or the operation mode in
ON.
Dead Lock System*
The Dead Lock System helps to prevent
theft. When the keyless entry system or the
keyless operation system has been used to
lock all of the doors and the tailgate, the
Dead Lock System makes it impossible to
unlock the doors using the inside lock knobs.