Wheel Covers - Mitsubishi ASX 2019 Owner's Manual

flat tyre or spare wheel, fit the installa-
tion clamp (A) by turning it clockwise,
and then install the spare tyre pad (B).
NOTE
l On vehicles with a T155/90D16 size spare
wheel, the clamp cannot be used for a nor-
mal size tyre.
3. Have your damaged tyre repaired as
soon as possible.
To store the tools and jack
Reverse the removing procedure when stor-
ing the jack, jack bar and wheel nut wrench.
Refer to "Tool and jack" on page 8-06.

Wheel covers*

To remove
Wrap the tip of the jack bar with a cloth, in-
sert it deeply into the notch provided in the
wheel cover, and pry the cover away from the
wheel. Using the same procedure at the other
wheel cover notches, work the wheel cover
away from the wheel to remove it complete-
ly.
CAUTION
l Removing the cover with your hands may
cause injury to the fingers.
NOTE
l The wheel cover is made of plastic. Pry it
loose carefully.
OGAE19E1
How to change a tyre
To install
1. Make sure the tabs (A) of the back of the
wheel cover are not broken and correctly
fitted on the rings (B). If in doubt, do not
install the wheel cover and consult a
MITSUBISHI MOTORS
Service Point.
2. Align the air valve (C) of the tyre with
the notch (D) in the wheel cover.
For emergencies
Authorized
8
8-19