Mitsubishi ASX 2019 Owner's Manual page 61

NOTE
l The function will be activated again if the
following operation is performed.
• If the doors and the tailgate are unlocked
using the keyless entry system or the key-
less operation function.
• If the ignition switch is turned to the
"ON" or "ACC" position (except for vehi-
cles equipped with the keyless operation
system).
• If the operation mode is put in ON or
ACC (vehicles with the keyless operation
system).
Cancelling the system
The following methods can be used to cancel
the system when it is in the system prepara-
tion mode or the system armed mode.
l
Pressing the UNLOCK switch on the re-
mote control switch.
l Turning the ignition switch to the "ON"
position (except for vehicles equipped
with the keyless operation system).
l
Putting the operation mode in ON (vehi-
cles equipped with the keyless operation
system).
l Opening any one of the doors or the tail-
gate, or inserting the key into the igni-
tion switch (except for vehicles equipped
with the keyless operation system) when
the system is in the system preparation
mode.
l
Holding the keyless operation key and
pressing the driver's or front passenger's
door lock/unlock switch, or the tailgate
OPEN switch to unlock the doors and
the tailgate (vehicles equipped with the
keyless operation system).
NOTE
l If the bonnet is opened during the system
preparation mode, the system preparation
condition is suspended.
The system returns to the system preparation
mode when the bonnet is closed.
l If the battery terminals are disconnected
while the system is in the system preparation
mode, the memory will be erased.
l It is possible to register up to 8 remote con-
trol switches for the keyless entry system
and 4 remote control switches for the key-
less operation system.
As long as they are registered, any of the re-
mote control switches, other than the one
used to activate the system, can be used to
cancel the system.
If you want to register additional remote
control switches, please
MITSUBISHI MOTORS Authorized Serv-
ice Point.
OGAE19E1
NOTE
l The activation distance for the keyless entry
system is approximately 4 m.
If it is not possible to lock or unlock the ve-
hicle by pressing the switch at the correct
distance or the security alarm system cannot
be set or cancelled using the switch, the bat-
tery may need to be replaced.
For further information, please consult a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
If you replace the battery yourself, refer to
"Procedure for replacing the remote control
switch battery" on pages 3-07, 3-23.
l If the UNLOCK switch on the remote con-
trol switch, or the driver's or front passeng-
er's door lock/unlock switch is pressed and
no door or the tailgate is opened within 30
seconds, the doors and the tailgate will auto-
matically relock. In this case as well, the
system preparation mode will go into effect.
l The time between pressing the UNLOCK
switch on the remote control switch, or the
driver's or front passenger's door lock/
unlock switch and automatic locking can be
adjusted. Please consult a MITSUBISHI
contact a MOTORS Authorized Service Point.
Locking and unlocking
Security alarm system*
3
3-37