Reversing Lamps - Mitsubishi ASX 2019 Owner's Manual

B- Stop and tail lamp (LED) - cannot be
replaced
C- Rear turn-signal lamps
NOTE
l
An LED, not a bulb, is used in the stop
lamp/tail lamp. Contact a MITSUBISHI
MOTORS Authorized Service Point when
there is a need for repair or replacement.
3. Pull the bulb out of the socket.
4. To install the bulb, perform the removal
steps in reverse.
NOTE
l
When mounting the lamp unit, align the
groove (D) on the lamp unit with the clip on
the body and the pin (E) on the unit with the
hole in the body.

Reversing lamps

1. Open the tailgate.
2. Insert a straight blade (or minus) screw-
driver into the notch of the cover and pry
gently to remove the cover.
OGAE19E1
Replacement of lamp bulbs
NOTE
l Wrap a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
cover.
3. Remove the socket and bulb assembly
by turning it anticlockwise.
Maintenance
10
10-31