Mitsubishi ASX 2019 Owner's Manual page 243

Back sensor (vehicles without a towing
bar)
Vehicle to obstacle Warning display/
distance sound cycle
Approx. 150 to Intermittent
80 cm
Approx. 80 to 40 cm Fast intermittent
Within approx. Continuous
40 cm
Back sensor (vehicles with a towing bar)
Vehicle to obstacle Warning display/
distance sound cycle
Approx. 150 to Intermittent
100 cm
Approx. 100 to Fast intermittent
60 cm
Within approx. Continuous
60 cm
CAUTION
l The distances given are to be used for refer-
ence only, as errors may be caused by vari-
ous factors, such as temperature, humidity,
or the shape of the obstacles.
NOTE
l When the sensors detect different obstacles
at the same time, the information screen in
the multi-information display indicates the
directions of the obstacles each sensor is de-
tecting. However, closer obstacles are given
priority over other detected obstacles and the
warning buzzer sounds to inform you of
closer obstacles.
Changing the detection areas
The detection areas can be changed as fol-
lows:
Vehicles with a towing bar
While the operation of the system is stopped
at the "SONAR" switch, push the "SONAR"
switch approximately 3 seconds or more, and
release it. The buzzer sounds twice to indi-
cate that the detection area has been changed.
Vehicles without a towing bar
While the operation of the system is stopped
at the "SONAR" switch, push the "SONAR"
switch approximately 3 seconds or more, and
release it. The buzzer sounds once to indicate
that the detection area has been changed.
OGAE19E1
Reversing sensor system*
NOTE
l The detection area will not change if you
keep the "SONAR" switch pushed for
10 seconds or more.
l After pushing the "SONAR" switch, revers-
ing sensor system operation differs accord-
ing to the detection area setting.
• Setting when towing bar is not equipped
When the gearshift lever or selector lever
is moved to the "R" position, the revers-
ing sensor system will operate even if cor-
ner sensor operation was stopped by push-
ing the "SONAR" switch.
• Setting when towing bar is equipped
When reversing sensor system operation
was stopped by pushing the "SONAR"
switch, the reversing sensor system will
not operate until the engine has been stop-
ped even if the gearshift lever or selector
lever is moved to the "R" position.
To resume reversing sensor system opera-
tion, push the "SONAR" switch or stop
and restart the engine, and then move the
gearshift lever or selector lever to the "R"
position.
Starting and driving
6
6-73