Indication Lamps; Warning Lamps; Brake Warning Lamp - Mitsubishi ASX 2019 Owner's Manual

Indication lamps

Indication lamps
Turn-signal indication lamps/
Hazard warning indication
lamps
These indication lamps blink
5
in the following situations.
• When the turn-signal
lever is moved to ac-
tivate a turn-signal
lamp.
Refer to "Turn-signal
lever" on page 5-59.
• When
warning
switch is pressed to
activate the hazard

warning lamps.

Refer
warning
switch"
5-59.
• When
warning lamps auto-
matically activate due
to
while driving.
Refer to "Emergency
stop signal system*"
on page 6-35.
5-46 Instruments and controls
NOTE
l If these indication lamps blink too fast due
to any operation other than sudden braking,
the cause may be a blown lamp bulb or a
faulty turn-signal connection.
High-beam indication lamp
Front fog lamp indication
the hazard
lamp*
flasher
to "Hazard
flasher
on page
Rear fog lamp indication lamp
the hazard
sudden braking
This indication lamp illumi-
nates when the high-beam is
used.
This lamp illuminates while
the front fog lamps are on.
This lamp illuminates while
the rear fog lamp is on.
OGAE19E1
Position lamp indication lamp
This indication lamp illumi-
nates while the position
lamps are on.
Warning lamps

Brake warning lamp

This lamp illuminates when
the ignition switch is turned
to the "ON" position or the
operation mode is put in ON,
and goes off after a few sec-
onds.
Always make sure that the lamp goes off be-
fore driving.
With the ignition switch or the operation
mode in ON, the brake warning lamp illumi-
nates under the following conditions:
l When the parking brake lever has been
engaged.
l When the brake fluid level in the reser-
voir falls to a low level.
l When the brake force distribution func-
tion is not operating correctly.