Mitsubishi ASX 2019 Owner's Manual page 31

Procedure for replacing the re-
mote control switch battery
Before replacing the battery, remove static
electricity from your body by touching a met-
al part such as doorknob of the room.
WARNING
l Danger of explosion if battery is incor-
rectly replaced.
Replace only with the same battery or an
equivalent type.
CAUTION
l When the remote control switch case is
opened, be careful to keep water, dust, etc.
out. Also, do not touch the internal compo-
nents.
NOTE
l You may purchase a replacement battery at
an electric appliance store.
l A MITSUBISHI MOTORS Authorized
Service Point can replace the battery for you
if you prefer.
1. Remove the screw (A) from the remote
control switch.
2. With the MITSUBISHI mark facing you,
insert the cloth-covered tip of a straight
blade (or minus) screwdriver into the
notch in the remote control switch case
and use it to open the case.
OGAE19E1
Keyless entry system*
NOTE
l Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out.
3. Remove the old battery.
4. Install a new battery with the + side (B)
up.
+ side
- side
Coin type
battery
CR1620
5. Close the remote control switch case
firmly.
6. Attach the screw (A) removed in step 1.
7. Check the keyless entry system to see
that it works.
Locking and unlocking
3
3-07