Check Engine Warning Lamp; Charge Warning Lamp - Mitsubishi ASX 2019 Owner's Manual

CAUTION
l In the situations listed below, brake perform-
ance may be compromised or the vehicle
may become unstable if brakes are applied
suddenly; consequently, avoid driving at
high speeds or applying the brakes suddenly.
Furthermore, the vehicle should be brought
to a stop in a safe location and to have it
checked.
• The brake warning lamp does not illumi-
nate when the parking brake is applied or
does not turn off when the parking brake
is released.
• The ABS warning lamp and brake warn-
ing lamp illuminate at the same time
For details, refer to "ABS warning lamp"
on page 6-37.
• The brake warning lamp remains illumi-
nated during driving.
l The vehicle should be brought to a halt in
the following manner when brake perform-
ance has deteriorated.
• Depress the brake pedal harder than usual.
Even if the brake pedal moves down to
the very end of its possible stroke, keep it
pressed down hard.
• Should the brakes fail, use engine braking
to reduce your speed and pull the parking
brake lever.
Depress the brake pedal to operate the
stop lamp to alert the vehicles behind you.

Check engine warning lamp

This lamp is a part of an on-
board diagnostic
which monitors the emis-
sions, engine control system
or CVT control system.
If a problem is detected in
one of these systems, this lamp illuminates or
flashes.
Although your vehicle will usually be driva-
ble and not need towing, we recommend you
to have the system checked as soon as possi-
ble.
This lamp will also illuminate when the igni-
tion switch is turned "ON" or the operation
mode is put in ON, and goes off after the en-
gine has started. If it does not go off after the
engine has started, we recommend you to
have the vehicle checked.
CAUTION
l Prolonged driving with this lamp on may
cause further damage to the emission control
system. It could also affect fuel economy
and drivability.
l If the lamp does not illuminate when the ig-
nition switch is turned to the "ON" position
or the operation mode is put in ON, we rec-
ommend you to have the system checked.
OGAE19E1
CAUTION
l If the lamp illuminates while the engine is
system
running, avoid driving at high speeds and
have the system
MITSUBISHI MOTORS Authorized Serv-
ice Point as soon as possible.
Accelerator pedal and brake pedal response
may be negatively influenced under these
conditions.
NOTE
l The engine electronic control module ac-
commodating the onboard diagnostic system
has various fault data (especially about the
exhaust emission) stored.

Charge warning lamp

This lamp illuminates when
the ignition switch is turned
"ON" or the operation mode
is put in ON, and goes off af-
ter the engine has started.
A warning is also displayed
on the multi-information display.
Instruments and controls
Warning lamps
inspected by a
5
5-47