Emergency Towing; Another Vehicle - Mitsubishi ASX 2019 Owner's Manual

Table of Contents

Advertisement

Towing
Turn the ignition switch to the "ACC" posi-
tion or put the operation mode in ACC and
secure the steering wheel in a straight-ahead
position with a rope or tie-down strap. Never
place the ignition switch in the "LOCK" po-
sition or put the operation mode in OFF when
towing.
Towing with front wheels off the
ground (Type C)
Release the parking brake.
Place the gearshift lever in the "N" (Neutral)
8
position (M/T) or the selector lever in the
"N" (Neutral) position (CVT).

Emergency towing

If towing service is not available in an emer-
gency, your vehicle may be temporarily tow-
ed by a rope secured to the towing hook.
If your vehicle is to be towed by another ve-
hicle or if your vehicle tows another vehicle,
pay careful attention to the following points:
If your vehicle is to be towed by

another vehicle

1. The front towing hook (A) is located as
shown in the illustration. Secure the tow
rope to the front towing hook.
8-22
For emergencies
NOTE
l
Do not use the tie-down hooks (B) for tow-
ing. These hooks are provided only for the
purpose of transporting the vehicle itself.
Using any part other than the designated
towing hook (A) could result in damage to
the vehicle body.
l
Using a wire rope or metal chain can result
in damage to the vehicle body. It is best to
use a non-metallic rope. If you use a wire
rope or metal chain, wrap it with cloth at any
point where it touches the vehicle body.
l
Take care that the tow rope is kept as hori-
zontal as possible. An angled tow rope can
damage the vehicle body.
2. Keep the engine running.
If the engine is not running, perform the
following operation to unlock the steer-
ing wheel.
[Except vehicles equipped with keyless
operation system]
OGAE19E1
Turn the ignition switch to the "ACC" or
"ON" position (M/T) or "ON" position
(CVT).
[For vehicles with the keyless operation
system]
Put the operation mode in ACC or ON
(M/T) or ON (CVT).
NOTE
l
For vehicles equipped with the Auto Stop &
Go (AS&G) system, press the "AS&G OFF"
switch to deactivate the AS&G system be-
fore stopping the vehicle.
Refer to "To deactivate" on page 6-18.
WARNING
l
When the engine is not running, the brake
booster and power steering system do not
operate. This means higher brake depres-
sion force and higher steering effort are
required. Therefore, vehicle operation is
more difficult than usual.
CAUTION
l
Do not leave the ignition switch in the
"LOCK" position or the operation mode in
OFF. The steering wheel will lock, causing
loss of control.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents