Ing Lamp - Mitsubishi ASX 2019 Owner's Manual

NOTE
l If the seat belt (A) or ring (B) becomes dirty,
the belt may not retract smoothly. If the seat
belt and ring are dirty, clean them with a
mild soap or detergent solution.
Driver's seat belt warning
lamp and display
Warning lamp
Warning display type 1
Warning display type 2
A tone and warning lamp are used to remind
the driver to fasten the seat belt.
If the ignition switch is turned to the "ON"
position or the operation mode is put in ON
while a seat belt is not fastened, the warning
lamp illuminates and the tone sounds for
about 6 seconds to remind the driver to fasten
the seat belt.
OGAE19E1
If the vehicle is driven without fastening the
seat belt, the warning lamp comes on and
flashes repeatedly, and the tone sounds con-
tinuously. At the same time, the warning dis-
play is displayed on the information screen in
the multi-information display.
The warning lamp goes off and the tone stops
after approximately 90 seconds.
Subsequently, if the seat belt is still not fas-
tened, the warning lamp and tone will be acti-
vated to remind the driver to fasten the seat
belt whenever the vehicle is stopped and star-
ted again. The warning will operate in the
same way if the seat belt is removed while
driving the vehicle. The warning will stop
when the seat belt is fastened.
Front passenger seat belt warn-

ing lamp*

The front passenger seat belt warning lamp is
located on the instrument panel.
Seat and seat belts
Seat belts
4
4-11