Mitsubishi ASX 2019 Owner's Manual page 51

CAUTION
l Do not set the Dead Lock System when
someone is inside the vehicle. With the Dead
Lock System set, it is not possible to unlock
the doors using the inside lock knobs. If you
erroneously set the Dead Lock System, un-
lock the doors using the UNLOCK switch
on the remote control switch or using the
keyless operation function.
Setting the system
1. Except for vehicles equipped with the
keyless operation system, remove the
key from the ignition switch.
For vehicles equipped with the keyless
operation system, put the operation
mode in OFF.
2. Get out of the vehicle. Close all of the
doors and the tailgate.
3. Press the LOCK switch (A) on the re-
mote control switch, the driver's or front
passenger's door lock/unlock switch (B),
or the tailgate LOCK switch (C) to lock
all of the doors and the tailgate. The
turn-signal lamps will blink once.
4. Press the switch again within 2 seconds.
The turn-signal lamps will blink three
times to show that the Dead Lock Sys-
tem has been set.
Except for vehicles equipped with the keyless
operation system
Vehicles equipped with the keyless operation system
OGAE19E1
Dead Lock System*
Driver's and front passenger's door lock/unlock
switches*
Tailgate LOCK switch*
NOTE
l Pressing the LOCK switch (A) on the re-
mote control switch once while the Dead
Lock System is set causes the turn-signal
lamps to blink three times, so it is possible to
confirm that the Dead Lock System is set.
Locking and unlocking
3
3-27