Installing The Switch On A Concrete Wall - Allied Telesis x950 Series Installation Manual

Installing the Switch on a Concrete Wall

Allied Telesis recommends a minimum of three people for this procedure.
To install the switch on a concrete wall, perform the following procedure:
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.  E105
Allied Telesis recommends installing the power supplies and optional
XEM2 Line Card before installing the switch on a wall. For instructions,
refer to "Installing PWR600 AC Power Supplies" on page 78 and "Installing
an Optional XEM2 Ethernet Line Card" on page 82.
1. Place the switch in a table.
2. Install the four brackets with sixteen screws that come with the switch
to the sides of the unit, as shown in Figure 55 on page 108.
3. Have two people hold the switch on the concrete wall at the selected
location for the device while you use a pencil or pen to mark the wall
with the locations of the four screw holes in the four brackets. Refer to
Figure 57 on page 112.
Please follow these guidelines as you position the switch on the wall:
Position the switch so that the front panel is either on the left or the

right. Refer to Figure 50 on page 100. You may not install the
switch with the front panel facing up or down.
Leave sufficient space from other devices or walls so that you can

access the front and back panels. Refer to "Recommended
Minimum Wall Area Dimensions" on page 101.
x950 Series Installation Guide for Stand-alone Switches
111