Removing The Bumper Feet; Figure 47: Removing The Bumper Feet - Allied Telesis x950 Series Installation Manual

Chapter 6: Installing the Switch in an Equipment Rack

Removing the Bumper Feet

The bumper feet included with the switch should not be used when
installing the device in an equipment rack. If they are already installed,
perform the following procedure to remove them:
1. Place the switch upside down on a level, secure surface.
2. Use a small flat-head screwdriver to gently pry the feet from the
bottom of the switch. Refer to Figure 47.
Figure 47. Removing the Bumper Feet
3. Turn the switch back over.
4. Go to"Installing the Switch" on page 95.
94