Saving Your Changes And Rebooting The Switch; Figure 69: Returning To The Privileged Exec Mode; Figure 70: Saving The Changes With The Write Command - Allied Telesis x950 Series Installation Manual

Chapter 8: Verifying and Configuring the Switch

Saving Your Changes and Rebooting the Switch

128
After disabling the VCStack feature or configuring ports 25 to 37, you have
to save your configuration changes and reboot the switch, as explained in
the following procedure:
1. From the Global Configuration mode, enter the EXIT command to
return to the Privileged Exec mode, as shown in Figure 67.
awplus(config)# exit
awplus#
Figure 69. Returning to the Privileged Exec Mode
2. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 68.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 70. Saving the Changes with the WRITE Command
If this is the first management session, the switch automatically
creates a Default.cfg configuration file in flash memory to store your
changes.
3. Enter the REBOOT command to reboot the switch.
4. At the confirmation prompt, type "Y" for yes.
5. Wait two minutes for the switch to complete initializing its management
software.
6. Examine the Switch ID LED again. The switch is ready for normal
network operations as a stand-alone unit if its ID number is "0." If the
number is not "0," repeat "Disabling VCStack" on page 122. Be sure to
save your configuration changes with the WRITE command.
7. Go to Chapter 9, "Cabling the Networking Ports" on page 129.