Eco-Friendly Button; Figure 10: Switch Id Led With The Eco-Friendly Mode Enabled - Allied Telesis x950 Series Installation Manual

Figure 10 illustrates the states of the LED when the eco-friendly mode is
enabled and the switch is operating in the low power mode.
eco-friendly
You use the eco-friendly button on the management panel to turn the
LEDs on or off. You might turn off the LEDs when you are not using them
Button
to monitor the switch, to conserve electricity. When the LEDs are off, the
overall power consumption of the chassis is reduced by approximately 2
watts.
The button controls all the port LEDs, except for the L/A LED for the NET
MGMT port. Additionally, the button does not control the LEDs on the
power supplies.
Note
You can use the SHOW SYSTEM ENVIRONMENT command in the
command line interface to identify the source of the problem.
The VCStack feature is disabled. The switch is operating
as a stand-alone device.
The switch is the master switch of a VCStack.
The switch is a member switch of a VCStack.
Figure 10. Switch ID LED with the eco-friendly Mode Enabled
x950 Series Installation Guide for Stand-alone Switches
33