Appendix 4 When Using Gx Developer; Appendix 4.1 Operation Of Gx Developer - Mitsubishi Electric MELSEC Q Series User Manual

Appendix 4
This section describes the operating procedure of GX Developer.
When using GX Developer, configure the parameter settings and the auto refresh settings with the sequence program.
• PROGRAMMING (
(1) Applicable software versions
For applicable software versions, refer to the following.
Page 22, Section 2.1 (4)
Appendix 4.1
Configure the following settings when using GX Developer.
Window name
I/O assignment
Intelligent function module
switch setting
(1) I/O assignment
Configure the setting on "I/O assignment" in "PLC parameter".
Parameter
Item
Type
Model name
Points
StartXY
When Using GX Developer
Page 111, CHAPTER 7)
Operation of GX Developer
Set the type of the module to be mounted and the I/O signal
range.
Configure the switch setting of the intelligent function
module.
[PLC parameter] [I/O assignment]
Select "Intelli.".
Enter the model name of the module.
The QD73A1 uses two slots. Select "Empty" and "0point" or "16points" for the first slot. Select "Intelli."
and "32points" for the second slot.
Enter any start I/O number of the QD73A1.
Application
Description
APPENDICES
Reference
Page 275, Appendix 4 (1)
Page 276, Appendix 4 (2)
275
A