Mitsubishi Electric MELSEC Q Series User Manual page 148

3.
Display the QD73A1's switch setting window, and configure the setting as follows.
Project window
Rotation direction setting
Accumulated pulse setting
Multiplication setting
OPR direction setting
OPR method setting
Encoder I/F setting
Analog voltage resolution setting
Feed back pulse addition/subtraction setting
Deviation counter clear setting
Zero/gain adjustment mode/Normal mode setting
4.
Write the set parameters to the remote I/O module, then reset the remote I/O module.
[Online]
146
[Intelligent Function Module]
Item
[Write to PLC...]
MODE
[QD73A1]
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set the near-point dog method or the count method.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set "Normal mode".
RESET
Press the switch
in this direction
for a while.
[Switch Setting]
Setting value