Mitsubishi Electric MELSEC Q Series User Manual page 270

Item
LED
Zero/gain adjustment
Mode switch
All the other specifications are the same.
268
QD73A1
RUN
ERR.
ZERO
GAIN
None (check with X signal)
None (check with X signal)
None (check with X signal)
None (check with X signal)
None (check with X signal)
None (check with X signal)
None (check in the buffer memory)
None (check in the buffer memory)
None (check with Y signal)
None (check with X signal)
None (check with X signal)
None (check with X signal)
None (check with X signal)
• Adjustment using the UP/DOWN switch
• Adjustment using the buffer memory
Intelligent function module switch
Specifications
AD70
ERR.1/ERR.2 (Minor/major error)
SV RDY (Servo READY signal)
DOG (Near-point dog signal)
STOP (Stop signal)
FLS (Upper limit signal)
RLS (Lower limit signal)
IN-POS. (In-position)
POLE (Deviation counter polarity)
N
2 (Deviation counter value)
PC RDY (PLC READY signal)
ZERO (OPR request signal)
EEX (Excessive error)
WDT ERR. (Hardware error)
V-MODE (Operating status)
Adjustment using volumes
DIP switch
A1SD70
None
None
None