Chapter 13 Common Functions; Module Status Monitor Function - Mitsubishi Electric MELSEC Q Series User Manual

CHAPTER 13
Functions referred to as "common function" can be used regardless of control method when necessary.
Common functions can be used on GX Works2.
13.1

Module Status Monitor Function

The "module status monitor function" monitors the module information, switch setting information, and external I/O
signal information. The module's detailed information can be displayed on the system monitor of GX Works2.
(1) Hardware LED information
The following LED statuses are displayed.
Item
RUN
ERR
BUSY
ZERO
GAIN
SV RDY
DOG
STOP
FLS
RLS
CHG
236
COMMON FUNCTIONS
Value
• 0000 : Indicates that the LED is off.
H
• 0001 : Indicates that the LED is on.
H
Condition to be 0001
Operating normally (same as the RUN LED)
Error occurrence
During positioning
Adjusting zero
Adjusting gain
Servo READY signal (READY) ON
Near-point dog signal (DOG) ON
Stop signal (STOP) ON
Upper limit signal (FLS) ON
Lower limit signal (RLS) ON
Speed-position switching command signal (CHANGE) ON
H