Mitsubishi Electric MELSEC Q Series User Manual page 278

(2) Intelligent function module switch setting
Configure the setting on "Switch setting" in "PLC parameter".
Parameter
Item
b7
0
0
0
0
0
0
0
0
1
Switch 1
276
[PLC parameter]
Bit
b0
Positive voltage is output when the positioning address increases.
0
Negative voltage is output when the positioning address increases.
1
b3 b2 b1
Fixed to 0 (Empty)
0 0 0
When a value is set, the value is ignored.
b6 b5 b4
0 0 0 -14800 to 14800 (default value)
0 0 1 -3700 to 3700 [Selection 1]
0 1 0 -7400 to 7400 [Selection 2]
0 1 1 -11100 to 11100 [Selection 3]
1 0 0 -14800 to 14800 [Selection 4]
1 0 1 -37000 to 37000 [Selection 5]
1 1 0 -74000 to 74000 [Selection 6]
1 1 1 -111000 to 111000 [Selection 7]
0 0 0 -148000 to 148000 [Selection 8]
b9 b8
0 0 4
0 1 2
1 0 1
1 1 1/2
b11 b10
Fixed to 0 (Empty)
0 0
When a value is set, the value is ignored.
b12
0 Reverse direction (address decreasing)
1 Forward direction (address increasing)
b13
0 Near-point dog method
1 Count method
b15 b14
Fixed to 0 (Empty)
0 0
When a value is set, the value is ignored.
[I/O assignment] Click the
Setting detail
Rotation direction setting
Accumulated pulse setting (unit: pulse)
Multiplication setting
OPR direction setting
OPR method setting
button.
Select "HEX.".

*1

