When Using The Module In A Standard System Configuration - Mitsubishi Electric MELSEC Q Series User Manual

7.3
When Using the Module in a Standard System
Configuration
This section introduces program examples where the following system configuration applies.
(1) System configuration
(2) Switch setting
Configure the switch setting as follows.
Project window
Item
Rotation direction setting
Accumulated pulse setting
Multiplication setting
OPR direction setting
OPR method setting
Encoder I/F setting
Analog voltage resolution setting
Feed back pulse addition/subtraction setting
Deviation counter clear setting
Zero/gain adjustment mode/Normal mode setting
QCPU
First half: X/Y0 to X/YF (Empty 16 points)
QD73A1
Second half: X/Y10 to X/Y2F (Intelli. 32 points)
QX41 X30 to X4F
[Intelligent Function Module]
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set the near-point dog method or the count method.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set this item according to the system to be used.
Set "Normal mode".
CHAPTER 7 PROGRAMMING
[QD73A1] [Switch Setting]
Setting value
7
115