Mitsubishi Electric MELSEC Q Series User Manual page 150

(6) Interlock program of MELSECNET/H remote I/O network
For programs introduced in Page 149, Section 7.4.1 to Page 177, Section 7.4.7, make interlocks using data link
status of the own station and the other station as shown below.
(7) Program example
Refer to the following.
Parameter setting program
Near-point dog method OPR program
Count method OPR program
Positioning control program
Two-phase trapezoidal positioning control program
Speed-position control switch mode program
Speed control operation program
Fixed-feed operation program
JOG operation program
Current value change program
Speed change program
Deviation counter clearing program
Stop program during positioning
148
Page 149, Section 7.4.1, Page 177, Section 7.4.7
Programs described in
Program example Reference
Page 149, Section 7.4.1
Page 151, Section 7.4.2 (1)
Page 154, Section 7.4.2 (2)
Page 157, Section 7.4.3 (1)
Page 159, Section 7.4.3 (2)
Page 161, Section 7.4.3 (3)
Page 164, Section 7.4.3 (4)
Page 167, Section 7.4.4
Page 170, Section 7.4.5
Page 172, Section 7.4.6 (1)
Page 174, Section 7.4.6 (2)
Page 176, Section 7.4.6 (3)
Page 177, Section 7.4.7