Figure 146 Rear View Of A Controller Enclosure (When The Eternus Dx100 S5/Dx200 S5 Is Installed With Only One Controller) - Fujitsu ETERNUS DX S5 Series Design Manual

6. Hardware Configurations
Controller Enclosure
●
Rear View
Figure 146
Only One Controller)
1
2 3
CM#0
CA#0
1
Controller (CM#0)
(Refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
3
Host interface (CA#0, CA#1)
(Refer to
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
5
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
7
Cover
Remove this when installing an additional controller (optional).
8
Power supply unit (PSU#0, PSU#1)
(Refer to
Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with
4 5 3 6
CA#1
PSU#0
8
"Controllers" (page 257).)
"■ PWC Ports" (page 263).)
"■ Host Interfaces" (page 259).)
"■ Drive Interface Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ Power Supply Units" (page
7
PSU#1
8
263).)
263).)
263).)
264).)
250 Design Guide