Test The Ip Connections - Avaya S8700 Installing Manual

236
Connecting to the Customer's Network
add data-module 30006
Data Extension: 30006
Network uses 1's for Broadcast Addresses? y
Set the Type field to ethernet.
2
3 Set the Port field to correspond to the circuit pack location.
The port number (final two digits) is always 33 for the TN2501AP circuit pack.
4 Set the Link field to an unassigned or next-available link number.
5 Set the Network uses 1's for Broadcast Address? field according to the
your network requirements.
6 Type a unique name in the Name field.
Press
7
Administer IP routing (if used)
1 Type add ip-route and press
Administer IP routes to the TN2501AP circuit pack.
2
Press
3

Test the IP connections

Click Start > Run to open the Run dialog box.
1
Type command and press
2
3 Type ping ipaddress, where ipaddress is a known computer on the network and press
Enter
4 Using Avaya Site Administration, type status link to test the new IP connections that
you have administered.
DATA MODULE
Type: ethernet
Port: 1b0333
Link: 5
to save your changes.
Enter
Enter
to effect the changes.
Enter
Enter
to verify connectivity.
October 2002
Name: VAL#2 Data Module
.
to open an MS-DOS command window.
Page 1 of 1