Troubleshooting; Error Messages - Toshiba DP125F Operator's Manual

TROUBLESHOOTING

Error Messages

If an abnormal condition arises
in the facsimile or an incorrect
operation is performed, an
alarm buzzer is generated for
about 4 seconds and a mes-
BROKEN
sage to indicate the nature of
REGISTRATION
the error appears in the LCD
window. In that case, take cor-
rective action according to the
following table.
POWER FAILURE
SCANNER COVER OPEN
TOP COVER OPEN
ENTRY MEMORY FULL
226
Error Message Cause / Solution
Autodialer numbers and initial
setting have been lost (due to a
long period of power failure,
etc.).
Press
state. If this Error Message is
repeatedly
programming has become cor-
rupted. The machine must be re-
initialized by a trained techni-
cian. Call for service.
A power failure occurred during a
communication, etc. The con-
tents of memory were cleared
due to a long power-off condi-
tion.
A Power Failure List is printed.
Confirm the list contents (see
page 225).
The scanner cover is open.
Firmly close the scanner cover.
The top cover is open.
Firmly close the top cover.
The memory set aside for speed
dial numbers (i.e. One Touch
Keys and Abbreviated Dial Num-
bers) has been exhausted.
Delete unneed numbers, alter-
nate numbers, and unnecessary
pauses. Use shorter names for
the dialing addresses.
Error Message
JOB MEMORY FULL
to restore the idle MEMORY OVERFLOW
displayed, machine
DOCUMENT JAM
PAPER JAM XX
UPPER PAPER EMPTY
MIDDLE PAPER EMPTY
Cause / Solution
The maximum number of manu-
ally input phone numbers (100)
has been reached.
Split your transmission into two
or more jobs.
There is not enough memory to
perform the requested operation.
Press to cancel the mes-
sage. Do the operation over
again with the Direct Document
Transmission, or do the opera-
tion again when enough residual
memory is regained. If the prob-
lem occurs frequently, you re-
quire additional memory.
A document jam has occurred.
Remove the jammed document
(see page 232).
A recording paper jam has oc-
curred (see page 228).
Remove the jammed paper (see
page 233).
No paper exists in the upper pa-
per tray.
Supply recording paper to the
upper paper tray.
No paper exists in the middle re-
cording paper tray.
This error occurs only with two
optional paper tray installed.
Supply recording paper to the
middle recording paper tray.