Error Codes Printed On Reports - Toshiba DP125F Operator's Manual

Error Codes Printed on Reports

When an Error Code is printed as a status indication on Transmission Reports, etc., refer to the following description for the applicable Error Code to determine the cause.
Error
Cause
Code
10 Paper Empty
11 Recording Paper Jam
12 Document Paper Jam
13 Operation Panel or Top Cover
Open
20 Power Failure
E0 Error relating to the printer or mem-
E6 ory.
22 File Error due to a Directory Error
30
was pressed during the com-
munication.
32 Page # Mismatch
33 Polling Error
How to Correct
Load recording paper and set the
tray.
Open the top cover and clear the
recording paper jam.
Remove the jammed document.
Close the cover or the panel, then
retry.
Retry the transmission or ask the
remote party to transmit the docu-
ment again.
Remove the cause of the error on
the printer, if any. Then ask the re-
mote party to retry the transmis-
sion. If not corrected, call your ser-
vice representative.
Power the unit ON/OFF, then retry.
Retry the transmission or ask the
remote party to transmit the docu-
ment again.
Check the actual document count.
Check polling options setup (securi-
ty code, etc.), and check if the poll-
ing document exists.
Error
Cause
Code
42 Memory Overflow
50 Line Busy
53 Security Mismatch in Relay or
Mailbox transmission
B0-B5 Signal Error or Line Condition Error
C0-C4
D0-D2
F0, F1
87 No residual memory was remain-
ing on the remote party's machine
for Relay or Mailbox transmission.
How to Correct
Wait until the memory is recov-
ered by completing some of the
reserved jobs or remove other
causes if any, then retry the com-
munication. If problem is continu-
al, acquire additional memory.
Send the document again.
Confirm the remote party's securi-
ty code, system password, and
your setup.
Retry the communication. Fre-
quent failure may indicate a phone
line problem. If possible, move the
unit to another line and try your
communications again.
Retry the transmission.
229