Table of Contents
Advertisement
- QUICK START
This section provides several
quick start programming steps
to prepare your new facsimile
1
for immediate use.
These procedures are a simple
version of the detailed proce-
dures listed in the manual. Next
Press:
to each procedure heading is a
convenient page number refer-
ence for the detailed procedure.
Should you have any difficulty
with these simple procedures,
refer to the pages listed for more
information.
It is highly recommended that
you take the time to read
Enter your user ID (company
through this manual to get the
name) using the Keyboard (see
most from your new TOSHIBA
page 36) and Numeric Keypad,
facsimile.
press:
If you communicate internation-
ally, select:
Otherwise, select:
34
Terminal ID
Setting the Terminal ID (Page 42)
SET TERMINAL ID
,
,
TEL NUMBER (MAX 20)
SET TERMINAL ID
Enter your facsimile's telephone
ID NAME =(MAX 40)
number, press:
Displayed for 2 seconds
If the Line-2 board is installed,
set the international code and
facsimile's telephone number for
line-2.
OPERATION COMPLETED
INT. CODE?
1.ADD+
2.NOT NEEDED
Displayed for 2 seconds
1.LANGUAGE
2.DATE & TIME
3.TERMINAL ID
4.DIAL TYPE
Press:
Transmitting
2
3
Sending a Facsimile
(Page 101)
Load your document face down
Your TOSHIBA facsimile has
into the Document Tray.
been preset from the factory to
receive facsimile messages. No
special setup is required to re-
MAY-17-00 WED11:49
ceive facsimile messages.
RESIDUAL MEMORY 100%
ENTER TEL NUMBER
Dial the remote facsimile using
the Dial Keypad located on the
Operation Panel. Remember to
include any access numbers
such as 9 or press the
af-
ter the access number if you
normally have to wait for a dial
tone.
After the remote facsimile num-
ber has been entered using the
keypad, press the green START
key.
Receiving
Receiving a
Facsimile (Page 112)
Advertisement
Chapters
Table of Contents
