Troubleshooting; Error Messages - Toshiba DP80F Operator's Manual

TROUBLESHOOTING

Error Messages

If an abnormal condition arises
in the facsimile or an incorrect
operation is performed, an alarm
buzzer is generated for about 4
seconds and a message to indi-
BROKEN REGISTRATION
cate the nature of the error ap-
pears in the LCD window. In
that case, take corrective action
according to the following table.
POWER FAILURE
RX COVER OPEN OR NO
PROCESS UNIT
MEMORY FULL
212
Error Message Cause / Solution
Autodialer numbers and initial
settings have been lost (due to a
long period without power or a
depleted backup battery).
Press
state. If this Error Message is re-
peatedly displayed, machine pro-
gramming has become corrupt-
ed. The machine must be re-initi-
atized by a trained technician.
Call for service.
A power failure occurred during a
communication, etc. The con-
tents of memory were cleared
due to a long power-off condi-
tion.
A Power Failure List is printed.
Confirm the list contents (see
page 211).
The top cover is open or no Ton-
er Cartridge and Drum Unit ex-
ists.
Firmly close the top cover or in-
stall the Toner Cartridge and
Drum Unit.
The memory set aside for speed
dial numbers (i.e. One Touch
Keys and Abbreviated Dial Num-
bers) has been exhausted.
Delete unneed numbers, alter-
nate numbers, and unnecessary
pauses. Use shorter names for
the dialing addresses.
Error Message
JOB MEMORY FULL
to restore the idle
MEMORY OVERFLOW
DOCUMENT JAM
PAPER SIZE ERROR OR
PAPER JAM XX
UPPER PAPER EMPTY
Cause / Solution
The maximum number of manu-
ally input phone numbers (100)
has been reached.
Split your transmission into two
or more jobs.
There is not enough memory to
perform the requested operation.
Press to cancel the
message. Do the operation over
again with the Direct Document
Transmission, or do the opera-
tion again when enough residual
memory is regained.
A document jam has occurred.
Remove the jammed document
(see page 218).
A recording paper jam has oc-
curred or paper size is mismatch.
Remove the jammed paper or
change the setting to select the
current paper size (see pages
21, 214, 219).
No paper exists in the upper pa-
per tray.
Supply recording paper to the
upper paper tray.